Safety Measures and Moves
Not legal advice. Always verify with the issuing authority and the permit text before moving. Editorial copy for reference — not a substitute for the official publication.
Official publication · Wyoming Secretary of State rules.wyo.gov (Amended, Eff. 4/30/2025)
WYDOT Motor Carrier Section · Chapter 5 § 5-8 — Safety Measures and Moves
§ 5-8. Safety Measures and Moves.
All oversize and/or overweight movements shall observe the following stipulations during the movement:
(a) Slow-moving Vehicle Emblem. Movements designed for operation at speeds of 25 miles per hour or less shall display a slow-moving vehicle emblem on the rear of the vehicle. Equipment or vehicles being hauled at speeds over 25 miles per hour shall have the slow-moving vehicle emblem covered or removed.
(b) Flags. Oversize movements are confined to daylight hours when travel conditions are favorable, except as provided in Section 7, Permitted Hours and Dates of Movement; Weather Conditions. The minimum flag size is 12 square inches, and flags shall be red or fluorescent orange. Flags shall be placed in the following manner:
(i) Front - fastened to each front corner of the vehicle and/or load if it exceeds legal width.
(ii) Rear - fastened to each rear corner of the vehicle and/or load if it exceeds legal width.
(iii) Side - fastened to mark any extremity when the extremity is wider than the front or rear of the vehicle and/or load.
(iv) Rear overhang on all oversize loads - fastened to the rear overhang that exceeds the end vehicle by four (4) feet or more.
(A) If the overhang is two (2) feet wide or less, only one (1) flag is required on the end.
(B) If the overhang exceeds two (2) feet wide, two (2) flags are required to indicate overhang width.
(c) Over Length Loads Authorized to Travel After Daylight Hours. Such loads shall require a red lamp and red reflector on each corner of the load. The lamp and reflector shall be visible from the rear and from each side to indicate maximum overhang. These lights shall be clearly visible at least 1,000 feet from each side and rear of the vehicle.
(d) Overwidth Vehicles or Loads Authorized to Travel After Daylight Hours. Such vehicles or loads shall require an amber clearance light on each front corner and a red clearance light on each rear corner of the load or vehicle, whichever is wider, as well as any extremity or projection. Such loads shall also display a revolving amber light, amber strobe light, or a pair of two-way flashing amber lights at least four (4) inches in diameter on the vehicle. LED assemblies meeting the visibility requirements shall be allowed. These lights shall be clearly visible at least 1,000 feet from the front and rear of the vehicle.
(e) Warning Signs. Oversize movements shall display warning signs that read OVERSIZE LOAD and that are fully visible from the front and rear. The signs shall have a yellow background and be at least 60 inches wide by 10 inches high, with black letters at least eight (8) inches high and one (1) inch wide printed on a single line. The signs shall be kept clean, shall be fully visible, and shall not cover lights, reflectors, or license plates on the vehicle. (i) Buses longer than 60 feet, but not exceeding 75 feet, shall not be required to display oversize load signs.
(ii) Oversize load signs shall not be displayed on motor vehicles, semitrailers, trailers, and escort vehicles after they have completed the permitted move or when such vehicles being operated do not exceed size limits.
(f) Mirrors. Motor vehicles constructed or loaded to obstruct the driver's view to the rear from the driver's position shall be equipped with outside mirrors on both sides and located to reflect to the driver a view of the roadway to the rear of the vehicle. If the vehicle is required to have a rear escort, the rear view mirrors do not have to be positioned outside the dimensions of the vehicle or load to reflect a view of the roadway to the rear of the vehicle. This paragraph in no way supersedes requirements in W.S. 31-5-954 or Title 49 Code of Federal Regulations (C.F.R.) § 393.80.
(g) Escorts for Width. Two (2) escorts (one front and one rear) shall be required on two-lane primary and secondary routes when any portion of the vehicle or load extends to the left of the highway centerline or the movement is 14 feet wide or greater. One (1) escort (rear) shall be required on interstate and divided highways and four-lane roadways with a left turn center lane when the movement is 15 feet wide or greater. An escorted movement primarily traveling on an interstate or divided highway shall be exempt from two-lane route escort requirements when traveling on a two-lane primary or secondary route is necessary to reach a port of entry and the distance traveled on the two-lane route does not exceed five (5) miles. WHP may require additional escorts depending on load width. Escorts shall maintain a distance of approximately 1,000 feet from the oversize load, unless a shorter distance is necessary to provide control over the move.
(h) Escorts for Length. On two-lane primary and secondary routes, two (2) escorts (one front and one rear) shall be required for movements 110 feet in overall length or for moves that extend to the left of the centerline at any time during the move. On interstate and divided highways, one (1) escort to the rear for length shall be required for movements 150 feet or longer in overall length or at the discretion of the OWL. An escorted movement primarily traveling on an interstate or divided highway shall be exempt from two-lane route escort requirements when traveling on a two-lane primary or secondary route is necessary to reach a port of entry and the distance traveled on the two-lane route does not exceed five (5) miles. Escorts shall maintain a distance of approximately 1,000 feet from the oversize load, unless a shorter distance is necessary to provide control over the move.
(i) Escorts for Rear Overhang. One (1) escort to the rear shall be required on all highways for rear overhangs of 25 feet or more. Escorts shall maintain a distance of approximately 1,000 feet from the oversize load, unless a shorter distance is necessary to provide control over the move. If the equipment has a permanent bumper meeting the requirements of 49 C.F.R. § 393.86 for rear impact guards and rear end protection, measurements begin at the rear of the bumper. If the equipment does not have a permanent bumper, measurements begin at the rear of the last tire at the back of the equipment.
(j) Escorts for Height. On all highways, any move exceeding 17 feet shall require an escort to the front with a height-measuring device. Permit-issuing authorities have the discretion to require escorts for heights 17 feet or less. An escort for height shall maintain a distance of approximately 1,000 feet from the load, unless a shorter distance is necessary to provide control over the move.
(k) Escorts for Overweight. Any overweight move with special restrictions imposed by the OWL shall require a rear escort on all highways. The OWL may require additional escorts depending on load restrictions. Escorts shall maintain a distance of approximately 1,000 feet from the load, unless a shorter distance is necessary to provide control over the move.
(l) Headlights and Taillights. All oversize vehicles shall have headlights and taillights illuminated and visible during movement.
(m) Utility Moves to Accommodate Load Movements. The permit holder shall determine if the vehicle or load dimensions can traverse the proposed route safely without damaging the highway, appurtenances, overhead wires, or structures. Should lifting overhead wires be necessary, the permit holder shall notify the utility in charge of such wires. The permit holder shall bear all costs incurred unless the wires are lower than regulations require. If the wires are lower than required, the utility shall pay for such costs.
(n) Local Approval. The permit holder shall contact city and/or county officials for approval for transportation on their roads.
(o) Damage. The permit is in no way a guarantee by the State of Wyoming or its agents that the load shall clear any structure or bridge. The applicant operating under this permit assumes full responsibility for all damage to highways, bridges, and appurtenances resulting from transporting the load described in the permit. The permit holder is also responsible for checking weather conditions and size and weight restrictions before and during the movement.
(p) Ports of Entry. All permitted loads shall stop at the first available port of entry, which shall not exceed five (5) miles from its route for each separate movement, and any port of entry along the route if directed by a regulatory sign, unless the permit-issuing authority approves an exception and such an exception is indicated on the permit.
Source
- Official URL: https://rules.wyo.gov/AjaxHandler.ashx?RULE_VERSION_ID=24634&handler=GetRuleVersionHTML
- Accessed: 2026-11-12
- Wyoming Secretary of State, Motor Carrier Chapter 5, effective 2025-04-30. The HTML has no section fragment. Section 8 is in that file.